CS-Lab Support Forum for CNC Community
Help to run this brand-new forum and stay with us.
Ask your questions, we are here to help!
SimCNC / CSMIO-IPS Digital Ouput problem
Hello,
I have a problem with my digital output (all digital output)
I want to connect my brake for axe Z
On the MotionKit3 module (which corresponds to my Z axis), I used the Drive Enable output signal to unlock the brake.
The indicator on the controller for the relevant output lights up, but nothing happens on the Finder relay coil side.
At first, I thought my relay was faulty, so I connected 24V directly via the power supply, and it switches fine.
On the csmio-ips, all 0V are common, and the blocks are properly powered by 24V. Except for the relevant outputs, where the value never changes (open/closed).
Is my board broken?
Bought used and reported as new.
I also purchased the license for this controller a week ago... I'm bummed if that's the case.
I am attaching a photo of the connection for example. Thank you for help
Uploaded files:
Hello,
please take a look at the image i uploaded to this post. I draw the line from Pin 14 to the GND (24VDC). With this connection it should work properly.
Have you tried to trigger the specific output by an script to check if this is working?
Regards
Dobbelju
Uploaded files:
Thank you very much ! its Working with your schematic !
I racked my brain for a few hours and you saved me ! 
Thank you again !
Nice! Glad to hear it worked.
Have fun with getting SimCNC running.
PARTNERS:
USA
Germany
Slovenia / Bosnia
Spain
South Africa
The Netherlands
Portugal
Greece
Hungary
Bulgaria
Kenya
Egypt
China
Serbia
Italy
Denmark
Finland
