CS-Lab Support Forum for CNC Community
Help to run this brand-new forum and stay with us.
Ask your questions, we are here to help!
Slave axe not well synchronized
Hello, I have two servomotor for Y axe, in Simcnc if I put them in master/slave the Synchro crash (the motor Number 3 is in fault mode after 5 or 10 mm), if I put them together physicaly in my csmio/ip-s all is ok.
Some advise?
I do not understand what you mean.
Show it on video so I can understand what you mean.
Hello everyone
I get in, I left mach3 to switch to sim cnc, can anyone tell me if in sim cnc I can manage the double motor on Y axis?
As a control board I have an IP-M, HBS86H act motor drivers and motors
Can you help me please, I can't find any instructions on the subject.
Thank you
Luca
In CSMIO/IP-M you can use two motors for the Y axis but without gate geometry correction.
To make the Y axis support two drives, add two motionKits to this axis.
PARTNERS:
USA
Germany
Slovenia / Bosnia
Spain
South Africa
The Netherlands
Portugal
Greece
Hungary
Bulgaria
Kenya
Egypt
China
Serbia
Italy
Denmark
Finland
